User's Manual
Table Of Contents
- Part G – Mounting and LED Indicators
- Mounting & Connector Information
- Antenna Port Cabling (Hazardous Installations)
- Product Labelling
- LED Indicators
- Part H – Programming and Diagnostics
- Programming
- Diagnostics
- Part I – K Series PCB Overlay & Schematics
- Schematics
- Overlay
- Part I – Specifications
- Appendix – FCC Approved Antennas
Page 18
© Copyright 2008 Trio DataCom Pty. Ltd.
O Series Data Radio – User Manual
Antenna Port Cabling (Hazardous Installations)
When the O Series OEM module is intended to be used in equipment which is compliant with Class I, Division 2 - Groups A,B,C,D Hazardous
Locations, the antenna conenctors need to be retained using a soldered connection as shown in the diagrams below. The method of soldered
retention will depend on the model of O Series OEM product in use. See below for model specifi c guidlines.
For O Series modules that have integtel mounting tabs, solder the TAB to the RF connector.
For O Series modules that have no TAB, solder a wire from the shield lid to the connector.