User's Manual

ManualsBrandsTrio Datacom ManualsElectronicsDATA RADIO- BASE STATION

Page 4

E Series Data Radio – User Manual

Warranty

All equipment supplied by Trio DataCom Pty Ltd is warranteed

against faulty workmanship and parts for a period of twelve (12)

months from the date of delivery to the customer. During the

warranty period Trio DataCom Pty Ltd shall, at its option, repair

or replace faulty parts or equipment provided the fault has not

been caused by misuse, accident, deliberate damage, abnormal

atmosphere, liquid immersion or lightning discharge; or where

attempts have been made by unauthorised persons to repair or

modify the equipment.

The warranty does not cover modiﬁcations to software. All

equipment for repair under warranty must be returned freight paid

to Trio DataCom Pty Ltd or to such other place as Trio DataCom

Pty Ltd shall nominate. Following repair or replacement the

equipment shall be returned to the customer freight forward. If it is

not possible due to the nature of the equipment for it to be returned

to Trio DataCom Pty Ltd, then such expenses as may be incurred

by Trio DataCom Pty Ltd in servicing the equipment in situ shall be

chargeable to the customer.

When equipment for repair does not qualify for repair or

replacement under warranty, repairs shall be performed at the

prevailing costs for parts and labour. Under no circumstances shall

Trio DataCom Pty Ltd’s liability extend beyond the above nor shall

Trio DataCom Pty Ltd, its principals, servants or agents be liable

for the consequential damages caused by the failure or malfunction

of any equipment.

Important Notice

This manual covers the operation of the E Series of Digital Data

Radios. Speciﬁcations described are typical only and are subject to

normal manufacturing and service tolerances.

Trio DataCom Pty Ltd reserves the right to modify the equipment,

its speciﬁcation or this manual without prior notice, in the interest

of improving performance, reliability or servicing. At the time of

publication all data is correct for the operation of the equipment

at the voltage and/or temperature referred to. Performance data

indicates typical values related to the particular product.

This manual is copyright by Trio DataCom Pty Ltd. All rights

reserved. No part of the documentation or the information supplied

may be divulged to any third party without the express written

permission of Trio DataCom Pty Ltd.

Same are proprietary to Trio DataCom Pty Ltd and are supplied

for the purposes referred to in the accompanying documentation

and must not be used for any other purpose. All such information

remains the property of Trio DataCom Pty Ltd and may not be

reproduced, copied, stored on or transferred to any other media or

used or distributed in any way save for the express purposes for

which it is supplied.

Products offered may contain software which is proprietary to Trio

DataCom Pty Ltd. However, the offer of supply of these products

and services does not include or infer any transfer of ownership

Part A - Preface

Warning - RF Exposure

The radio equipment described in this user manual emits low level

radio frequency energy. The concentrated energy may pose a

health hazard depending on the type of antenna used. In the case

of:

Non-directional antenna - DO NOT allow people to come within 0.5

metres (20 inches) of the antenna when the transmitter is operating

Directional antenna - DO NOT allow people to come within 6

metres (20 feet) of the antenna when the transmitter is operating.

Compliance Information

FCC Notice (Hot Standby Controller Only)

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the

instruction, equipment may cause harmful interference to radio

communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the

following measures:

• Re-orient to relocate the receiving antenna.

• Increase the separation between the equipment and

receiver.

• Connect the equipment into an outlet on a circuit different to

that which the receiver is connected.

• Consult the dealer or an experienced radio/television

technician for assistance.

IC Notice (Hot Standby Controller Only)

This Class B digital apparatus complies with Canadian ICES-003.

Cet appariel numerique de la class B est conforme a la norme

NBM-003 du Canada.

R&TTE Notice (Europe)

In order to comply with the R&TTE (Radio & Telecommunications

Terminal Equipment) directive 1999/5/EC Article 3 (Low Voltage

Directive 73/23/EEC), all radio modem installations must include an

external in-line lightning arrestor or equivalent device that complies

with the following speciﬁcations:

• DC Blocking Capability - 1.5kV impulse (Rise Time 10mS,

Fall Time 700mS) (Repetition 10 Times) or 1.0kV rms 50Hz

sine wave for 1 minute.

Part A – Preface