User's Manual

4. Rechargeable Battery Pack
It is recommended that before using, charge the unit by placing the Hand Set in the Base Set for at least
3~5 hours.
Replacing the Battery Pack
a. Remove the battery cover on the Hand Set
b. Turn the power switch OFF (located in the battery storage area)
c. Detach the battery pack cable from Hand Set
d. Connect the new battery pack to the Hand Set and then turn the power switch ON (located in
the battery storage area)
e. Close the battery cover
5. Recommendations
a. Prior to use, charge the unit by placing the Hand Set in the Base Set for at least 3~5 hours
b. The LED on the Base Set indicates Charging Mode. If LED light does not turn on, call the
A/S center
c. If the Hand Set is not in use for long periods, turn the power switch OFF (located in the
battery storage area).
d. Check the LED on Hand Set for Low Battery status
e. Charge Hand Set when not in use for short periods
6. Troubleshooting
Problems Check Points
No reception
- check the battery status
- check the connection and cables
- check the communication range
Poor reception, static, noise
- change the location of Base Set
- check the communication range
- check to see if placed near TV, speakers, or other electronic devices