User's Manual

3. Base and Hand Set Installation
Base Set
a. Connect the RJ-45 connector to the Base Set
b. Connect the Microphone (optional Headset) to the Base Set
Hand Set
a. The battery pack is not built-in the Hand Set for safety reasons. Connect the battery pack
to the Hand Set and then turn the power switch ON (located in the battery storage area)
b. Prior to use, charge the unit by placing the Hand Set in the Base Set for at least 3~5 hours
c. Connect the Microphone (optional Headset) to the Hand Set
RJ-45 Connector Pin Description
① VCC : DC power (10V ~ 16V DC)
② GND : DC power GND
③ RX Audio : RX Audio signal + TX Audio signal
④ GND :
⑤ TX Audio(AUX) : TX Audio
⑥ RF module ON : (TTL : “L”)
⑦ RF Loop ON : Hand, Base Set Loop ON signal (TTL : “L”)
⑧ MIC/Headset ON : MIC/Headset ON signal (TTL : “L”)
Beep Tone
Power ON/OFF---------------------------Æ Beep
Low Battery ----------------------------Æ Bee- Beep
Connection Established --------------------Æ Beep~
Hand and Base Set Recognition --------------Æ Beep~
Charging Mode ---------------------------Æ Beep~
Paging from Base Set----------------------Æ Beep~ Beep ~ Beep (continuously)
Out of Communication Range-----------------Æ Bee-Bee-Beep
Disconnection----------------------------Æ Beep