User's Manual

17
2
CAUTION
Warning
(1) Immediately discontinue use of the battery if, while using, charging, or
storing the battery, the battery emits an unusual smell, feels hot,
changes color, changes shape or appears abnormal in any other way.
Contact your authorized reseller or Panasonic if any of these
problems are observed.
(2) Do not place the batteries in microwave ovens, high-pressure containers,
or on induction cookware.
(3) In the event that the battery leaks and the fluid gets into one’s eye, do not
rub the eye. Rinse well with water and immediately seek medical care.
If left untreated the battery fluid could cause damage to the eye.
Caution
(1) If the device is to be used by small children, an adult should explain the
contents of the user’s manual to the children. The person should
provide adequate supervision to insure that the device is being used
as explained in the user’s manual.
(2) When the battery is worn out, insulate the terminals with adhesive tape or
similar materials before disposal.
Danger
Be sure to follow the rules listed below while charging the battery. Failure to
do so may cause the battery to become hot, explode, or ignite and
cause serious injury.
· When charging the battery, either use a specified battery charger or
otherwise insure that the battery charging conditions specified by
Panasonic are met.
· Do not attach the batteries to a power supply plug or directly to a vehicle’s
cigarette lighter.
· Do not place the batteries in or near fire, or into direct sunlight. When the
battery becomes hot, the built-in safety equipment is activated,
preventing the battery from charging further, and overheating the
battery, which would destroy the safety equipment and can cause
additional heating, breaking, or ignition of the battery.
Battery Replacement
The battery should be replaced only by Panasonic Service Center.
AUDIT LOG INFORMATION-1
Category Log Item Parameter
Event
Recording Start [factor] [mode] [factor] = Start Event Name
[mode] = Event / Cont Stop
Recording Stop [factor]
[Event Name]
[factor] = <Stop EV>
Event name (when recording stopped)
I/O status change event 2'nd camera attached/detached
USB attached/detached
Power supplied/removed
Wi-Fi disconnected with [mode]
[Electric field strength]
[mode] = ST1/ST2/AP
[MAC] = Mac address of AP
[FREQ] = Channel
[SSID] = SSID of AP
[Electric field strength -dB]
Net [mode] [IP] [VPU Serial] [mode] = ST1/ST2/AP
[IP] = IP address
[VPU Serial] = only ST1
Deleted [Event ID] [Event ID] = Event Name
Delete Error [Event ID] [Event ID] = Event Name
USB authentication success /
failure
Uploading Start / End [with
Error/timeout]
Remote Updating Start / End [with
Error/timeout]
Status
Low battery
SD [Model Number] [SD Status]
[Capacity] [Free Space] [Serial#]
[Model Number] = See meta file spec
[SD Status] = Status number .
[Capacity] = Total capacity (Kbytes).
See config1.xml.
[Free Space] = Free Space (Kbytes).
See config1.xml.
[Serial#] = Serial number of SD
SD card capacity is not enough