User's Manual

CAUTION
1 18
AUDIT LOG INFORMATION-2
1. When Using the Battery
Danger
(1) Misusing the battery may cause the battery to get hot, explode,
or ignite and cause serious injury. Be sure to follow the safety rules
listed below:
- Do not place the battery in fire or heat the battery.
- Do not install the battery backwards so that the polarity is reversed.
- Do not connect the positive terminal and the negative terminal of the
battery to each other with any metal object (such as a wire).
- Do not carry or store the batteries together with necklaces, hairpins,
or other metal objects.
- Do not pierce the battery with nails, strike the battery with a hammer,
step on the battery, or otherwise subject it to strong impacts or shocks.
- Do not solder directly onto the battery.
- Do not expose the battery to water or salt water, or allow the battery
to get wet.
(2) Do not disassemble or modify the battery. The battery contains
safety and protection devices which, if damaged, may cause the
battery to generate heat, explode or ignite.
(3) Do not place the battery on or near fire, stoves, or other high
temperature locations. Do not place the battery in direct sunlight,
use or store the battery inside cars in hot weather. Doing so may
cause the battery to generate heat, explode, or ignite.
Using the battery in this manner may also result in a loss of
performance and a shortened life expectancy.
(4) Do not insert the battery into equipment designed to be hermetically
sealed. In some cases hydrogen or oxygen may be discharged from
the cell which may result in rupture, fire or explosion.
CAUTION : Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
(Please refer to instruction for safe disposal of lithium
polymer battery at page#3)
Category Log Item Parameter
System
Power on/off
System reboot by [event] [event] : a factor of reboot
System Start [Product Name]
[Firmware Version] [Serial#]
Standby Start / End
Configuration is changed
Configuration error [file.setting]
Log in/out [officer ID] [officer ID]
Restoring FAT Start
Restoring FAT End [with Error]
SD formatted [with Error]
Factory default
Upgrading/Downgrading Start
[Firmware File Name]
[Firmware Version]
Upgrading/Downgrading End [with
Error]
GPS Enabled / Disabled
Time adjustment [Before] [After] [Before] = UTC time before adjustment
[After] = UTC time after adjustment