User's Manual
Table Of Contents
- Support
- Safety and General Information
- Regulatory Information
- System Overview
- About this Guide
- Package Contents
- Transmitter Controls and Features
- Transmitter Indications
- Receiver Controls and Features
- Desktop Charger Controls and Features
- Getting Started
- Operation
- Troubleshooting
- Care and Maintenance
- Specifications
6 Wireless Microphone System
RF Exposure Compliance and Control Guidelines and Operating
Instructions
To control your exposure and ensure compliance with the general
population/uncontrolled environment exposure limits, always adhere to
the following procedures:
Guidelines
• User awareness instructions should accompany this electronic device
when transferred to other users.
• Do not use this electronic device if the operational requirements
described herein are not met.
Operating Instructions
Wireless Microphone
• When worn on the body, always place the microphone in a
Motorola-approved clip, holder, holster, case, or body harness for this
product. Using approved body-worn accessories is important because
the use of non-Motorola-approved accessories may result in exposure
levels, which exceed the IEEE/ICNIRP general
population/uncontrolled environment RF exposure limits.
• If you are not using a body-worn accessory and are not using the
microphone in the intended use position, then ensure the antenna and
the microphone are kept 2.5 cm (one inch) from the body when
transmitting. Keeping the electronic device at a proper distance is
important because RF exposures decrease with increasing distance
from the antenna.
Wireless Microphone Base
The base complies with FCC RF exposure limits set forth for an
uncontrolled environment. The base should be installed and operated
with a minimum distance of 20cm between the antenna and all persons.
Approved Accessories
Use only Motorola-approved supplied or replacement antennas and
accessories. Use of non-Motorola approved antennas and accessories
may exceed IEEE/ICNIRP RF exposure guidelines.