User's Manual
Table Of Contents
- Support
- Safety and General Information
- Regulatory Information
- System Overview
- About this Guide
- Package Contents
- Transmitter Controls and Features
- Transmitter Indications
- Receiver Controls and Features
- Desktop Charger Controls and Features
- Getting Started
- Operation
- Troubleshooting
- Care and Maintenance
- Specifications
24 Wireless Microphone System
Troubleshooting
Problem Check List
No sound is
recorded
• Make sure the Transmitter is powered on.
• Make sure the Transmitter’s battery is charged
(Low Battery LED Indicator is turned off).
• Make sure the Record LED Indicator on the
Receiver blinks red once to confirm pairing when
docked inside the Receiver.
• Make sure recording is active (Press the Record
button - the Record LED indicator is turned on).
• Make sure the Transmitter is not muted. (Toggle
the Mute button).
• Make sure the built-in microphone on the
Transmitter is not obstructed.
• Make sure the Wired/Lapel Microphone (if used) is
properly plugged into the Transmitter.
• Make sure the Out of Range LED Indicator is
turned off.
• Check the power cord connection to the Receiver.
• Check the system cord connection to the Receiver.
• Check the antenna connection to the Receiver.
• Check the incoming audio at the recording system.
Poor reception,
static, noise,
distorted sound
• Try to maintain 1000 feet line-of-sight between
Transmitter and Receiver.
• Check for radio interference with other equipment
on site.
No status
indications
coming from the
Transmitter
• Make sure the Transmitter is powered on.
• Remove the Transmitter out of Covert mode (see
Transmitter Controls and Features on page 18).