User's Manual
Table Of Contents
- Support
- Safety and General Information
- Regulatory Information
- System Overview
- About this Guide
- Package Contents
- Transmitter Controls and Features
- Transmitter Indications
- Receiver Controls and Features
- Desktop Charger Controls and Features
- Getting Started
- Operation
- Troubleshooting
- Care and Maintenance
- Specifications
User Guide 23
Getting Started
1. Switch on the Transmitter (the power switch is at the bottom of the
Transmitter). All LEDs lit for three seconds and three beeps are
emitted or/and the Transmitter vibrates.
2. Dock the Transmitter inside the Receiver base. The Record LED
Indicator on the Receiver blinks red once to confirm that pairing with
the Receiver is completed.
NOTE When using the Transmitter for the first time, turn-off the Transmitter and
leave it in the Receiver base to charge for at least 3.5 hours.
3. Remove the Transmitter from the Receiver base.
4. Attache the Transmitter to your shirt or plug the Lapel Microphone into
the jack on the Transmitter and clip the Microphone onto your lapel.
IMPORTANT The Transmitter or Lapel Microphone must be used in a distance of
more than 4 inches from the user mouth to prevent audio
degradation.
5. Place the Transmitter inside the pouch and clip the pouch to your belt.
Operation
• To switch the Transmitter on/off - use the power switch at the
bottom of the Transmitter.
• To start recording - press the Record button. Confirm visually that
the Record LED indicator has turned solid red.
• To mute the microphone - press the Mute button to mute or unmute.
• To set Vibrate mode - from Beep mode (default mode), press the
Mode button once.
• To set Beep and Vibrate mode - from beep mode (default mode),
press the Mode button twice.
• To mute the Transmitter and maintain all LED indicators turned
off - from Beep mode (default mode), press the Mode button three
times.
NOTE Turn off the Transmitter when not in use for long periods of time.