User's Manual

7 8
DESCRIPTION – Receiver (RX) INSTALLATION & OPERATION
Installation must only be conducted by a qualified technician.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Installation:
1) Install the mounting bracket by using the screws
2) Slide the RX set onto the bracket
3) Connect the main cable to the RX
4) Connect external antenna to the RX
Antenna Location:
1) Place external antenna on the windshield at the point
(Horizontal or Vertical) as shown in the following picture:
Operation:
1) Charge TX for at least 3 hours
2) Switch the power on (located on the bottom of the TX)
3) Place TX into RX to synchronize
Note: Disconnect the battery or turn off the device when the TX is not in use
for long period of time.