User's Manual

3 4
TIP 1: How to undock TX from RX and Desktop Charger
LED Indication on TX and RX
To prevent units from being broken, undock
the TX from the RX as shown in the image to
the right.
Battery LED on RX:
RED ON when the battery is charging
GREEN ON when the battery is fully charged
DESCRIPTION – RX Main Cable
RJ-45 Plug Pin Description
1. Power In +: Connects to the engine battery
2. Power In –: Connects to the engine battery(GND)
3. Audio Out: Connects to “Audio In” port in the back of the
recorder
4. Audio Out GND: Connects to “Audio In” port in the back of the
recorder
5. AUX Status: Connects to GPIO cable
6. Sync Status: Connects to GPIO cable
7. Reserved
8. VPU’s REC Command: Connects to GPIO cable
9. REC Status: Connects to GPIO cable
10. MUTE Status: Connects to GPIO cable
Caution:
Please do not attempt to use ARB-HT3G wiring harness or equipment
in combination with CCR24PNA wiring harness or equipment. They are
not intended to be combined and each has their own specification.
Improper installation will result in equipment malfunction