Instruction Manual

4
5. SETTING ALARM VOLUME: “V - ” IS LIGHTING UP ON THE DISPLAY:
i. PRESSING SKIP UP OR SKIP DOWN BUTTON TO SELECT THE ALARM VOLUME,
PRESS TIMER BUTTON AGAIN TO CONFIRM.
6. SETTING ALARM IS COMPLETED, THE DISPLAY WILL SHOW THE SETTING AGAIN FOR USER’S
CHECKING
7. “CLOCK” ICON IS FLASHING WHEN ALARM IS IN ACTIVE. “CLOCK” ICON LIGHTS UP WHEN
ALARM IS SETTING IS STORED BUT NOT IN ACTIVE YET.
8. CANCEL ALARM: DURING STANDBY MODE, WHEN “CLOCK” ICON IS ON, PRESS TIMER
BUTTON, “CLOCK” ICON WILL BE OFF.
TIMER FUNCTION
1. PUSH THE STANDBY KNOB TILL THE STANDBY INDICATOR (RED COLOR) LIGHT OFF. UNIT IS
TURNING FROM STANDBY MODE TO OPERATION MODE.
2. WHEN THE UNIT IS TURNED ON, PRESS SLEEP BUTTON REPEATEDLY TO CHOOSE THE
SLEEP TIME MINUTES FROM 90>80>70…..>10 OFF.
3. SLEEP TIME SETTING IS STORED WHEN THE “SLEEP” ICON LIGHTS UP ON THE DISPLAY.
4. WHEN THE SLEEP TIME MINUTES IS OVER, UNIT WILL BE SWITCHED TO STANDBY MODE
AUTOMATICALLY.
LISTENING TO FM/AM RADIO
RADIO TUNING
1. PRESS FUNCTION BUTTON REPEATEDLY TO ACTIVATE “FM” OR “AM” MODE.
2. TUNE TO THE REQUIRED STATION BY TURNING TUNING KNOB TO TUNE THE RADIO
FREQUENCY, WHICH IS SHOWN ON THE RADIO DIAL SCALE.
3. SELECT DESIRED VOLUME BY TURNING VOLUME KNOB.
HINTS FOR BETTER RECEPTION
1. AM: THERE IS A BUILT-IN AM BAR ANTENNA. IF AM RECECPTION IS WEAK, SLIGHTLY
ROTATING OR RE-POSITIONING OF THE UNIT WILL USUALLY IMPROVE THE AM RECEPTION.
2. FM : THE RECEIVER HAS A BUILT-IN FM WIRE ANTENNA HANGING AT THE REAR CABINET.
THIS WIRE SHOULD BE TOTALLY UNRAVELED AND EXTENDED FOR BEST RECEPTION.
FM RADIO ENCODING
1. PRESS FUNCTION BUTTON REPEATEDLY TO ACTIVATE “FM” MODE.
2. INSERT MEMORY DEVICE (USB DRIVE)
3. PRESS THE REC BUTTON, IT WILL TAKE 3-5 SECONDS TO READ MEMORY DEVICE. THEN USB
ICON WILL BE FLASHING.
4. THE USB OR SD ICON WILL BE FLASHING ON THE DISPLAY DURNIG ENCODING.
5. TO FINISH ENCODING, PRESS STOP BUTTON AND DISPLAY WILL SHOW “END” AND
RETURN TO “FM” MODE.
REMARK:-
- THE RECORDING SPEED IS 1:1 AND ACCORDING TO THE ACTUAL PLAYING TIME OF FM OR
FM-ST RADIO
- THE RECORDING FORMAT IS PRESET AT – MP3 BIT RATE : 128 KBPS
- DURING FM RADIO ENCODING, RADIO FREQEUNCY IS FXIED AND CANNOT BE TUNED
- THE ENCODING QUALITY DEPENDS ON THE RADIO RECEPTION. IF THE RADIO RECEPTION
IS NOT CLEAR, IT MAY AFFECT THE FM RADIO ECODING QUALITY.
PHONO & ENCODING
NOTED:
- REMOVE THE STYLUS PROTECTOR.
- BE SURE THAT THE TONE ARM IS BEING DETACHED FROM THE
TONE ARM REST BEFORE OPERATING AND RE-SECURED AGAIN
AFTERWARDS.