Owner Manual (Wall Cabinet)

5
Lift the cabinet and hang it carefully on
two hooks of WALL BRACKET(M) through
two square holes on the back side of
cabinet. Two people are needed, DO NOT
attempt this alone.
There are two small round holes on the
back side of cabinet. Use a pencil to mark
off the fastening location on the wall
through the holes. Drill holes in marked
locations. Insert ANCHOR (L) completely
into each drilled hole. Insert SCREWS (K)
through the round holes on cabinet into
anchors. Fasten the screws tightly with a
Phillips screwdriver.
ASSEMBLY INSTRUCTIONS
STEP 7
K (2) L (2)
Attach SHELF SUPPORT (H) by
hooking it over the position tab
at your desired height. Make
sure all four SHELF SUPPORTS (H)
are at the same level.
Tilt SHELF (H) diagonally to
move it inside the cabinet. Place
SHELF (E) on top of all four
SHELF SUPPORTS (H).
H (4) E (1)
STEP 8
Shelf supports hooked
on position tabs
Hook
Small round hole
Square hole
L
K
H
E