OWNER’S MANUAL 24” Garage Wall Cabinet Model
PARTS LIST 24” Garage Wall Cabinet should include the following parts. Please inspect box contents to ensure you have received all components. You will need a Phillips screwdriver for assembly which is not provided.
ASSEMBLY INSTRUCTIONS STEP 1 Unfold CABINET BODY (A). A (1) STEP 2 Two people are recommended for ease of assembly. Stand the unfolded CABINET BODY (A) upside down on the floor. C (1) J (8) 2 Note: There is a 40mm diameter hole on the back panel of the CABINET BODY (A). When the CABINET BODY (A) is upside down, this hole should be in the upper left corner of the back panel. 1 Turn BOTTOM PANEL (C) upside down. Tilt the front diagonally downward.
ASSEMBLY INSTRUCTIONS STEP 3 DOOR (D) can be installed on the left OR right side of the cabinet. Only install one hinge in this step. RIGHT INSTALLATION: Position DOOR HINGE-G (G) on the left front corner of the outside of BOTTOM PANEL (C) and align the holes. Make sure the pivot of hinge faces down. LEFT INSTALLATION: Position DOOR HINGE-F (F) on the right front corner of the outside of BOTTOM PANEL(C) and align the holes. Make sure the pivot of hinge faces down.
ASSEMBLY INSTRUCTIONS STEP 5 J Attach DOOR (D) to the cabinet front by sliding the bottom door cylinder over the DOOR HINGE (F or G) installed in Step 3. F (1) J (4) Open Left Position remaining DOOR HINGE (G or F) to the left or right front corner of TOP PANEL (B). Make sure to insert the pivot of DOOR HINGE into the top door cylinder first. Align holes on DOOR HINGE (G or F) to preinstalled nuts on frame of CABINET BODY (A).
ASSEMBLY INSTRUCTIONS STEP 7 Lift the cabinet and hang it carefully on two hooks of WALL BRACKET(M) through two square holes on the back side of cabinet. Two people are needed, DO NOT attempt this alone. There are two small round holes on the back side of cabinet. Use a pencil to mark off the fastening location on the wall through the holes. Drill holes in marked locations. Insert ANCHOR (L) completely into each drilled hole. Insert SCREWS (K) through the round holes on cabinet into anchors.
USAGE INSTRUCTIONS SHELF ADJUSTMENT Ensure all products have been removed from the shelf. To adjust the shelf, take the shelf out of the cabinet and re-attach the shelf supports to the position tabs at your desired height. Tilt the shelf diagonally to move it inside the cabinet. Place the shelf on top of all four shelf supports. Position Tabs LOCK AND UNLOCK Insert the key into the lock on the right door. Turn it clockwise 90 degree to lock the door. Turn it counter-clockwise 90 degree to unlock the door.
Description Description Door 1) Top Panel 9) 2) Cabinet Body 10) Door Handle 3) Magnetic Catcher 11) Door Hinge-G 4) Shelf 12) Black Screw 5) Shelf Support 13) Wall Bracket 6) Bottom Panel 14) Mounting Screw 7) Key 15) Anchor 8) Door Hinge-F 15 14 1 13 2 12 3 11 4 10 5 9 8 7 7 6
WARNINGS 1. Read and understand all instructions. Failure to follow all instructions may result in injury and/or damage. 2. The warnings, cautions, and instructions discussed in this manual cannot cover all possible conditions or situations that may occur. The user must always be aware of their environment and ensure that they use the product in a safe and responsible manner. 3. Do NOT modify the product in any way.
1 YEAR LIMITED WARRANTY 24” Garage Wall Cabinet International Industries warrants to the original consumer purchaser (“Purchaser”) of the 24“ Garage Wall Cabinet (“Product”) that each Product shall be free from defects in workmanship and materials for a period of 1 year from the date of original purchase.
