Installation & Assembly (Garage Wall Cabinet)

STEP 6

ASSEMBLY INSTRUCTIONS

STEP 5

Attach DOOR (D) to the cabinet front by

sliding the bottom door cylinder over the

DOOR HINGE (F or G) installed in Step 3.

Position remaining DOOR HINGE (G or F) to

the left or right front corner of TOP PANEL (B).

Make sure to insert the pivot of DOOR HINGE

into the top door cylinder first.

Align holes on DOOR HINGE (G or F) to pre-

installed nuts on frame of CABINET BODY (A).

Insert (2) BLACK SCREWS (J) through the

DOOR HINGE (G or F) and (2) through TOP

PANEL (B). Tighten fully with a Phillips

screwdriver.

G (1) F (1)

J (4)

D (1)

M (1)

K (2)

L (2)

Position WALL BRACKET (M) on the wall at the desired

height.

If needed, use a pencil to mark off the mounting location

on the wall through one of the oval holes on each end of

WALL BRACKET (M). Drill holes in marked locations.

Insert ANCHOR (L) completely into each drilled hole.

Fasten SCREWS (K) through the oval holes on WALL

BRACKET (M) into the wall or anchors tightly with a

Phillips screwdriver.

Note: Please consult a local contractor if you are unsure

if your wall is able to bear the load of the wall cabinet.

Open Left

Open Right

pivot

cylinder