Installation & Assembly (Garage Wall Cabinet)

J (4)

STEP 4

DOOR (D) can be installed on the left OR right

side of the cabinet. Only install one hinge in this

step.

RIGHT INSTALLATION:

Position DOOR HINGE-G (G) on the left front

corner of the outside of BOTTOM PANEL (C) and

align the holes. Make sure the pivot of hinge

faces down.

LEFT INSTALLATION:

Position DOOR HINGE-F (F) on the right front

corner of the outside of BOTTOM PANEL(C) and

align the holes. Make sure the pivot of hinge

faces down.

Insert (2) BLACK SCREWS (J) through the DOOR

HINGE (F or G) and (2) through BOTTOM PANEL

(C). Tighten fully with a Phillips screwdriver.

Stand the unit right side up.

Tilt front of TOP PANEL (B) diagonally downward. First, insert the

lip into the inner side of the tab of CABINET BODY (A) at the right

side, then insert into the left side.

Note: Do not install screws in the two holes at the right or left

front corners of TOP PANEL (B) until instructed.

ASSEMBLY INSTRUCTIONS

STEP 3

G (1)

B (1)

F (1)

J (8)

Follow the order indicated, insert (6) BLACK SCREWS (J)

through the hole on each back corner and four holes on

the back side of TOP PANEL (B). Tighten them fully with a

Phillips screwdriver. Insert (2) SCREWS (J) through the tabs

on front of CABINET BODY (A) and tighten them fully to

TOP PANEL (B).

Open Left

Open Right

pivot

lip

tab