Installation & Assembly (Garage Wall Cabinet)

STEP 2

Unfold CABINET BODY (A).

A (1)

J (8)

Two people are recommended for ease of assembly.

Stand the unfolded CABINET BODY (A) upside down

on the floor.

Note: There is a 40mm diameter hole on the back

panel of the CABINET BODY (A). When the CABINET

BODY (A) is upside down, this hole should be in the

upper left corner of the back panel.

ASSEMBLY INSTRUCTIONS

STEP 1

C (1)

hole

Turn BOTTOM PANEL (C) upside down. Tilt the front diagonally

downward. First, insert the lip into the inner side of the tab of

CABINET BODY (A) at the right side, then insert into the left side.

Note: Do not install screws in the two holes at the right or left

front corners of BOTTOM PANEL (C) until instructed.

Follow the order indicated, insert (6) BLACK SCREWS (J) through

the hole on each back corner and four holes on the back side of

BOTTOM PANEL (C). Tighten them fully with a Phillips

screwdriver. Insert (2) BLACK SCREWS (J) through the tabs on

front of CABINET BODY (A) and tighten them fully to BOTTOM

PANEL (C).

lip

tab