24” Garage Wall Cabinet
PARTS LIST Your 24” Garage Wall Cabinet should include the following parts. Please inspect box contents to ensure you have received all components. If you are missing any parts, need assistance with assembly or have questions, please contact Customer Service. You will need a Phillips screwdriver for assembly which is not provided.
ASSEMBLY INSTRUCTIONS STEP 1 Unfold CABINET BODY (A). A (1) STEP 2 Two people are recommended for ease of assembly. Stand the unfolded CABINET BODY (A) upside down on the floor. C (1) J (8) 2 Note: There is a 40mm diameter hole on the back panel of the CABINET BODY (A). When the CABINET BODY (A) is upside down, this hole should be in the upper left corner of the back panel. 1 Turn BOTTOM PANEL (C) upside down. Tilt the front diagonally downward.
ASSEMBLY INSTRUCTIONS STEP 3 DOOR (D) can be installed on the left OR right side of the cabinet. Only install one hinge in this step. RIGHT INSTALLATION: Position DOOR HINGE-G (G) on the left front corner of the outside of BOTTOM PANEL (C) and align the holes. Make sure the pivot of hinge faces down. LEFT INSTALLATION: Position DOOR HINGE-F (F) on the right front corner of the outside of BOTTOM PANEL(C) and align the holes. Make sure the pivot of hinge faces down.
ASSEMBLY INSTRUCTIONS STEP 5 J Attach DOOR (D) to the cabinet front by sliding the bottom door cylinder over the DOOR HINGE (F or G) installed in Step 3. F (1) J (4) Open Left Position remaining DOOR HINGE (G or F) to the left or right front corner of TOP PANEL (B). Make sure to insert the pivot of DOOR HINGE into the top door cylinder first. Align holes on DOOR HINGE (G or F) to preinstalled nuts on frame of CABINET BODY (A).
ASSEMBLY INSTRUCTIONS STEP 7 Lift the cabinet and hang it carefully on two hooks of WALL BRACKET(M) through two square holes on the back side of cabinet. Two people are needed, DO NOT attempt this alone. There are two small round holes on the back side of cabinet. Use a pencil to mark off the fastening location on the wall through the holes. Drill holes in marked locations. Insert ANCHOR (L) completely into each drilled hole. Insert SCREWS (K) through the round holes on cabinet into anchors.
USAGE INSTRUCTIONS SHELF ADJUSTMENT Ensure all products have been removed from the shelf. To adjust the shelf, take the shelf out of the cabinet and re-attach the shelf supports to the position tabs at your desired height. Tilt the shelf diagonally to move it inside the cabinet. Place the shelf on top of all four shelf supports. Position Tabs LOCK AND UNLOCK Insert the key into the lock on the right door. Turn it clockwise 90 degree to lock the door. Turn it counter-clockwise 90 degree to unlock the door.
SERVICE PARTS LIST Part Number Description Part Number Description 1) PBK-16-004-2411 Top Panel 9) PBK-08-008-2319 Door 2) PBK-18-018-2412 Cabinet Body 10) AMA-05-019-1850 Door Handle 3) XBK-02-001-0003 Magnetic Catcher 11) PBK-09-012-0001 Door Hinge-G 4) PBK-03-052-2410 Shelf 12) XBK-01-004-0612 Black Screw 5) XSV-02-017-0001 Shelf Support 13) PBK-19-005-2402 Wall Bracket 6) PBK-16-003-2411 Bottom Panel 14) ZSV-01-003-0530 Mounting Screw 7) XBK-10-001-0XXX Key 15)
