Installation & Assembly

ASSEMBLY INSTRUCTIONS
STEP 1
Location of parts:
1) KEYS (H) are hooked to key leash mounted
inside Drawer.
2) LINERS (G) are inside Drawer.
3) CASTERS (B/C) / CASTER BOLTS (D) / SHELF
SUPPORTS (F) and HOOKS (I) are boxed inside
Cabinet.
4) SHELF (E) is inside bottom Cabinet.
1
3
© 2020 TRINITY - 800.985.5506
2
2
4
STEP 2
With two people, carefully lay WORKBENCH (A) on
its backside. Do NOT attempt this alone.
Position LOCKING CASTERS (B) on side of
WORKBENCH (A) of your choice and align holes to
pre-installed nuts on underside of WORKBENCH
(A). Use a 14mm socket wrench to fully tighten
CASTER BOLT (D) to WORKBENCH (A).
Repeat above steps to install NON-LOCKING
CASTERS (C).
Notes:
* Make sure to install both LOCKING CASTERS (B)
on same side of workbench, either left or right
side. Do NOT install both on front or back side.
** For ease of use, place LOCKING CASTERS (B) on
side you will regularly push.
*** If you plan to push the workbench against a
wall, push NON-LOCKING CASTER (C) against the
wall first then swing LOCKING CASTERS (B) against
the wall.
B (2) C (2) D (16) 14mm
B
C
D