Installation & Assembly

ManualsBrandsTrinity ManualsGarage & Outdoor Storage & OrganizationBasics 31" W Butcher Block Top Workbench

Your TRINITY Basics Stainless Steel Workbench w/ Pegboard should include the following parts. Please

inspect box contents to ensure you have received all components.

If you are missing any parts, need assistance with assembly or have questions, please contact TRINITY

Customer Service: 800.985.5506 or customerservice@trinityii.com. Parts can also be requested online

via “Contact Us” section at www.trinityii.com.

You will need 14mm wrench (for casters) and 12mm wrench (for pegboard) for assembly. These are

NOT included.

CASTER

BOLT (16)

M10

LINER (3)

E G H

LOCKING

CASTER (2)

NON-LOCKING

CASTER (2)

KEY (4)

WORKBENCH

w/PEGBOARD (1)

PARTS LIST

HOOK (10)

SHELF (1) SHELF

SUPPORT (4)

Summary of content (8 pages)

PAGE 1
PARTS LIST Your TRINITY Basics Stainless Steel Workbench w/ Pegboard should include the following parts. Please inspect box contents to ensure you have received all components. If you are missing any parts, need assistance with assembly or have questions, please contact TRINITY Customer Service: 800.985.5506 or customerservice@trinityii.com. Parts can also be requested online via “Contact Us” section at www.trinityii.com. You will need 14mm wrench (for casters) and 12mm wrench (for pegboard) for assembly.
PAGE 2
ASSEMBLY INSTRUCTIONS STEP 1 1 2 Location of parts: 3 1) KEYS (H) are hooked to key leash mounted inside Drawer. 4 2) LINERS (G) are inside Drawer. 3) CASTERS (B/C) / CASTER BOLTS (D) / SHELF SUPPORTS (F) and HOOKS (I) are boxed inside Cabinet. 4) SHELF (E) is inside bottom Cabinet. STEP 2 With two people, carefully lay WORKBENCH (A) on its backside. Do NOT attempt this alone.
PAGE 3
ASSEMBLY INSTRUCTIONS STEP 3 Carefully lift Workbench upright. Two people are needed. Do NOT attempt this alone. 12mm Unscrew bottom Bolt on left and right side of Pegboard with a 12mm socket wrench. Lift Pegboard upright. With one person holding Pegboard in place, have second person insert bottom Bolt into top hole of each bracket. Securely tighten both Bolts back with socket wrench. BOTTOM BOLT PEGBOARD TOP HOLE BOTTOM BOLT BRACKET 3 © 2020 TRINITY - 800.985.
PAGE 4
ASSEMBLY INSTRUCTIONS STEP 4 SHELF (E) is shipped inside the bottom cabinet. Tilt SHELF (E) diagonally and remove it from cabinet. E (1) F (4) Position Tab Attach SHELF SUPPORT (F) by hooking it over position tab at desired height. Make sure all four SHELF SUPPORTS (F) are at same level. Tilt SHELF (E) diagonally to move it inside cabinet. Place SHELF (E) on top of all four SHELF SUPPORTS (F). You can adjust shelf height position by removing shelf, re-locating shelf supports and replacing shelf.
PAGE 5
ASSEMBLY INSTRUCTIONS STEP 6 Hang HOOKS (I) into holes on pegboard at your desired location. I (10) 5 © 2020 TRINITY - 800.985.
PAGE 6
USAGE INSTRUCTIONS DRAWER REMOVAL Pull drawer out so that it is almost fully extended. On RIGHT-hand side, push black release lever DOWN. On LEFT-hand side, pull black release lever UP. While holding levers as instructed, pull drawer forward until released from slides attached to Workbench (“Workbench Slides”). Note: Slides attached to drawer (“Drawer Slides”) are an integral part of drawer and must be removed along with drawer itself. DRAWER REPLACEMENT To replace drawer, pull slides out completely.
PAGE 7
SERVICE PARTS LIST – TLS-4820 TRINITY Customer Service provides the following replacement parts: 7 Part Number Description Part Number Description 1) XBK-02-047-0001 Key leash 13) XBK-22-007-2717 Shelf Liner 2) XBK-10-001-0XXX Key 14) ZSV-99-004-5020 Locking Caster 3) XBS-07-013-2716 Drawer 15) XBS-08-015-2114 Left Door 4) LNA-06-015-3119 Wood Top 16) AMA-05-007-2000 Door Handle 5) ZSV-12-010-1575 Slide (workbench side) 17) XBK-23-010-3012 End cap 6) AMA-05-007-2600 Dra
PAGE 8
SERVICE PARTS LIST – TLS-4820 TRINITY Customer Service provides the following replacement parts: NOTE: Replacement keys may be ordered using the code shown on the face of the lock. 1 24 23 2 22 3 21 4 20 5 19 6 18 7 17 8 16 9 15 10 14 11 13 12 © 2020 TRINITY - 800.985.