Wall cabinet installation and assembly

ASSEMBLY INSTRUCTIONS

Lift CABINET BODY (A) and hang it carefully

on WALL BRACKET(D) through four hooks on

back side of cabinet. Two people are needed,

DO NOT attempt this alone.

There are two slots on back side of cabinet.

Align these two slots to two small round

holes on WALL BRACKET (D). Insert SHORT

SCREWS (E) through slots from inside of

cabinet and fasten tightly to WALL BRACKET

(D) with a Phillips screwdriver.

STEP 1

STEP 2

A (1) E (2)

D (1) G (4)

Position WALL BRACKET (D) on wall at desired

height, making sure it is level.

Mark off mounting location on wall through oval

holes on WALL BRACKET (D). If ANCHORS (G) are

required, drill holes in marked locations. Insert

ANCHOR (G) completely into each drilled hole.

Fasten LONG SCREWS (F) through oval holes on

WALL BRACKET (D) into wall or anchors tightly with

a Phillips screwdriver.

Note: Please consult a local contractor if you are

unsure if your wall is able to bear the load of the

wall cabinet.

F (4)

hook