Base cabinet installation and assembly

ASSEMBLY INSTRUCTIONS
Attach SHELF SUPPORT (C) by hooking it over
position tab at desired height. Make sure all
four SHELF SUPPORTS (C) are at the same level.
Tilt SHELF (B) diagonally to move it inside
cabinet. Place SHELF (B) on top of all four SHELF
SUPPORTS (C).
Repeat above to install other shelf.
© 2018 TRINITY - 800.985.5506
3
STEP 1
STEP 2
B (2) C (8)
A
D
C
A (1) D (4)
B
Lay CABINET BODY (A) gently on its
back. Two people are needed, Do
NOT attempt this alone.
Screw FEET LEVELER (D) fully into
each pre-installed nut on four
corners of cabinet bottom.
Stand cabinet right side up.
Move it to desired location. Adjust
FEET LEVELER (D) as needed to
ensure your cabinet is level and
stable.