Wall cabinet installation and assembly

Table Of Contents

ASSEMBLY INSTRUCTIONS

Place two WALL BRACKETS (D) to other end of back edge of

Wood Top as shown. Make sure one bracket is as close as

possible to end of unsupported end of wood top.

Insert WOOD SCREW (B) into each top hole and tighten them

fully to wood top edge with a Philips screwdriver.

With 2 people, carefully slide assembled unit to wall at desired

location. Do NOT lift assembly by wood top.

Mark off mounting location on wall through bottom holes on

WALL BRACKET (D). If WALL ANACHORS (E) are required, drill

holes in marked locations. Insert WALL ANCHOR (E) completely

into each drilled hole.

Fasten WALL SCREWS (F) through bottom holes on WALL

BRACKET (D) into the wall or anchors tightly with a Philips

screwdriver.

Note: Please consult a local contractor if you are unsure if

your wall is able to bear the load of the Wood Top.

B (4)

D (2) E (4) F (4)

Wood Top

Base Cabinet

Wood Top

Back Edge

Option 2 (Installed on 1 Base Cabinet)