Warranty

ASSEMBLY INSTRUCTIONS

Place two WALL BRACKETS (D) to back edge of the overhang

Wood Top as shown. Make sure one bracket is as close as

possible to end of unsupported end of wood top.

Insert WOOD SCREW (B) into each top hole and tighten them

fully to Wood Top edge with a Philips screwdriver.

With 2 people, carefully slide assembled unit to wall at desired

location. Do NOT lift assembly by wood top.

Mark off mounting location on wall through bottom holes on

WALL BRACKET (D). If WALL ANCHORS (E) are required, drill

holes in marked locations. Insert WALL ANCHOR (E) completely

into each drilled hole.

Fasten WALL SCREWS (F) through bottom holes on WALL

BRACKET (D) into the wall or anchors tightly with a Philips

screwdriver.

Note: Please consult a local contractor if you are unsure if your

wall is able to bear the load of the Wood Top.

B (4)

D (2) E (4) F (4)

Wood Top

Base Cabinet

Wood Top

Back Edge

Optional Installation with Wood Top Overhang