Installation Guide

ASSEMBLY INSTRUCTIONS
Unscrew the screws securing the Nut to
the bottom of the FAUCET (C) assembly
and remove the Nut w/Screws, Steel
Washer and Rubber Gasket.
Insert FAUCET (C) assembly through the
hole on the SINK (A) ledge from the top
side. Make sure the Base is on top of the
SINK (A). Orient the faucet handle
toward the front. From under the SINK
(A), first slide on the Rubber Gasket, then
the Steel Washer, and lastly, screw in the
Nut, pointed upward. Tighten the Nut as
much as you can by hand and tighten the
screws if necessary.
STEP 3
C (1)
C
On top of
the sink
Under
the sink
Faucet
Base
Rubber
Gasket
Nut w/
Screws
Steel
Washer
Carefully move the sink into desired
location and adjust FEET LEVELERS
until the sink is stable and level.
Connect the HOSES and DRAIN to
plumbing system.
STEP 4
© 2016 TRINITY - 800.985.5506
4