Installation Guide

ASSEMBLY INSTRUCTIONS
Carefully turn the sink right-side up,
standing on the legs.
Unscrew the large 3-3/8” Nut from the
bottom of the DRAIN (D) assembly.
Insert DRAIN (D) through the opening at
the bottom of the SINK (A) from the
inside. From under the SINK (A) first
slide the Rubber Washer on, then the
Paper Gasket, and finally, tightly screw
the large 3-3/8” Nut back on. A pipe
wrench could be used to tighten if
necessary.
Lay the SINK (A) upside-down and insert
LEG (B) into the round collars on the
bottom of the SINK (A).
Use the HEX KEY (F) to tighten the HEX
SCREW (E) into the SINK (A). Turn the
HEX KEY (F) as far clockwise as
possible. Take out the HEX KEY (F),
reposition, reinsert, and turn as far
clockwise as possible, repeating as
necessary until the HEX SCREW (E) is
securely in place.
Repeat for each LEG (B).
STEP 1
STEP 2
E (4) F (1)
B (4)
B
A
A (1)
D
E
F
D (1)
Inside
the sink
Under
the sink
Drain
Rubber
Washer
Paper
Gasket
3-3/8”
Nut
© 2016 TRINITY - 800.985.5506
3