Warranty

ASSEMBLY INSTRUCTIONS
© 2018 TRINITY - 800.985.5506
3
STEP 3
Lay WORKBENCH (A) on its backside. Two people
are needed. Do NOT attempt this alone.
Position LOCKING CASTERS (D) on side of
WORKBENCH (A) of your choice and align holes to
pre-installed nuts on underside of WORKBENCH
(A). Use a 14mm socket wrench to fully tighten
CASTER BOLT (F) to WORKBENCH (A).
Repeat to install NON-LOCKING CASTERS (E).
Notes:
* Make sure to install both LOCKING CASTERS (D)
on same side.
** For ease of use, place LOCKING CASTERS (D) on
side you will regularly push or pull.
*** If you plan to push workbench against a wall,
place LOCKING CASTERS (D) on front long side for
ease of access.
A
Carefully lift WORKBENCH (A) upright. Two people
are needed. Do NOT attempt this alone.
Place LINERS (G) in each drawer.
G (7)
STEP 4
E
D
F
G
A
F (16)
14mm
E (2)
D (2)