Instructions / Assembly

USAGE INSTRUCTIONS

DRAWER REMOVAL

DRAWER REPLACEMENT

Pull the drawer out so that it is almost fully

extended. On the RIGHT-hand slide, push the

black release lever DOWN. On the LEFT-hand

slide, pull the black release lever UP. While

holding the levers as instructed, pull the

drawer forward until released from the slides

attached to the Tool Chest (“Tool Chest Slides”).

Note: The slides attached to the drawer

(“Drawer Slides”) are an integral part of the

drawer and must be removed along with the

drawer itself.

To replace the drawer, pull the slides out completely. Insert the brackets on each side of the Drawer

Slides into the corresponding slots on the Tool Chest Slides, making sure they are properly positioned.

Once the brackets are inserted into the slots, completely close the drawer to set all slides in their

proper positions.