Instructions / Assembly

ASSEMBLY INSTRUCTIONS
Attach screw stud end of GAS LIFTS
(G) to insert nuts on Side Panels and
tighten with WRENCH (L).
If you are having trouble aligning the
GAS LIFT’S (G) screw stud into the
side panel, adjust the LID (A) up and
down as needed.
Note: We recommend a second
person help with this step by lifting
the LID (A) to properly align GAS
LIFT (G) screw stud end with insert
nut on Side Panels so that it can be
fully tightened.
Insert a GAS LIFT SCREW (I) first through the
round hole of the fitting on GAS LIFT (G).
Then insert the second GAS LIFT SCREW (I)
through the slot of the fitting. Fasten tightly
to LID (A) with short end of HEX KEY (K).
Do this for both GAS LIFTS (G).
STEP 5
STEP 6
L (1)
© 2017 TRINITY - 800.985.5506
4
K (1)
I (4)G (2)
L
G
I
K
Round hole
Slot
Round hole
Slot