Use and Care Manual

ASSEMBLY INSTRUCTIONS

For easiest assembly, do not attach the TOP (D), MIDDLE

(E) and BOTTOM (F) POLES until instructed. Once

connected, these will be the posts for the Organizer.

Note that each POLE (D+E+F) has slight horizontal line

indentations at 1” intervals. Each SLIP SLEEVE (J) has

raised horizontal lines inside designed to lock them in

place on the POLE (D+E+F).

On all (6) BOTTOM POLES (F) place 1 pair of SLIP SLEEVES

(J) at the lowest position, position closest to the CASTERS

(K). Please make sure the arrow faces up and that the

word “TOP” is right side up.

Slide the pair of SLIP SLEEVES (J) until you hear a click to

confirm the pair is locked onto the BOTTOM POLE (F).

DO NOT place more than one pair on each POLE (F) at a

time.

Screw each CASTER (K) into the bottom of

each BOTTOM POLE (F). Turn clockwise to

screw in place.

Tighten the CASTER (K) completely using

the included Caster Wrench. Failure to

do as instructed could result in the caster

stem breaking.

STEP 1

STEP 2

F (6) K (6)

J (12)

* Note: There will be a very small gap in-between the SLIP SLEEVES (J)—this is normal.