Instructions / Assembly

ASSEMBLY INSTRUCTIONS

A (4) I (8)

* Note: There will be a very small gap in-between two locked SLIP SLEEVES (I)—this is normal.

STEP 1

STEP 2

Screw each CASTER (J & K) into the bottom of

each BOTTOM POLE (A). Turn clockwise to

screw in place. Make sure LOCKING CASTERS

are on the same side.

Use provided caster wrench to tighten

completely. Failure to do as instructed could

result in the caster stem breaking.

A (4) K (2)

On BOTTOM POLE (A), place 1 pair of SLIP SLEEVES (I) at

the desired level no higher than the 3

indentation from

the bottom. Please make sure the arrow faces up and

that the word “TOP” is right-side up. Do this for each

BOTTOM POLE (A) and make sure slip sleeve heights are

identical for all BOTTOM POLES (A).

Note that each POLE (A & B) has slight horizontal line

indentations at 1” intervals. Each SLIP SLEEVE (I) has

raised horizontal lines inside designed to lock in place on

the POLE (A & B).

Slide the pair of SLIP SLEEVES (I) until you hear a click to

confirm the pair is locked onto BOTTOM POLE (A). DO

NOT place more than one pair on each POLE (A & B) at a

time.

J (2) L (1)