Use and Care Manual

ASSEMBLY INSTRUCTIONS

STEP 1: SLIP SLEEVES

STEP 2: INSTALLING BOTTOM SHELF

A (4) C (8)

B (1)

Note that each POLE (A) has slight horizontal line

indentations at 1” intervals. Each SLIP SLEEVE (C) has

raised horizontal lines inside designed to lock them in

place on the POLE (A).

On the POLE (A), place 1 pair of SLIP SLEEVES (C) at the

desired level. Please make sure the arrow faces up and

that the word “TOP” is right side up. Do this for each

POLE (A) and make sure that the heights are identical for

POLE (A).

Slide the pair of SLIP SLEEVES (C) until you hear a click to

confirm the pair is locked onto the POLE (A). DO NOT

place more than one pair on each POLE (A) at a time.

* For safety and stability, the lowest SHELF (B) should be lower than the 3

notch from the bottom.

** Note: There will be a very small gap in-between the SLIP SLEEVES (D)—this is normal.

Place SHELF (B) on its side and slide the (4) POLES (A) through the

holes in the SHELF (B). Make sure that the SHELF (B) corner

cylinders are positioned over the SLIP SLEEVES (C).

Stand the unit upright.

*Note: The TRINITY logo on the corner cylinders should be right-

side up.

**Use a rubber mallet, if needed, to secure the SHELVES (B).