Use and Care Manual

ASSEMBLY INSTRUCTIONS

Note: There will be a very small gap in-between two locked SLIP SLEEVES (D)—this is normal.

A (4)

D (8)

C (1)

Place SHELF (C) on its side and slide (4) BOTTOM

POLES (A) through the holes in SHELF (C). Make

sure that SHELF (C) corner cylinders are

positioned over SLIP SLEEVES (D).

Stand the unit upright.

Note

• The level side of SHELF (C) is the TOP side (the

TRINITY logo on the corner cylinders should

be right-side up).

• Use a rubber mallet, if needed, to secure

SHELF (C).

For easiest assembly, do not attach TOP (B) and BOTTOM (A)

POLES until instructed. Once connected, these will be the posts

for the rack.

Note that each POLE (A+B) has slight horizontal line

indentations at 1” intervals. Each SLIP SLEEVE (D) has raised

horizontal lines inside designed to lock them in place on POLE

(A+B).

On BOTTOM POLE (A), place 1 pair of SLIP SLEEVES (D) at the

desired level no higher than the 3

indentation from the

bottom. Please make sure the arrow faces up and that the

word “TOP” is right side up. Do this for each BOTTOM POLE (A)

and make sure that SLIP SLEEVE (D) heights are identical for all

(4) BOTTOM POLES (A).

Slide the pair of SLIP SLEEVES (D) until you hear a click to

confirm the pair is locked onto BOTTOM POLE (A). DO NOT

place more than one pair on each POLE (A) at a time.

STEP 1

STEP 2