Instructions / Assembly

ASSEMBLY INSTRUCTIONS

A (4) D (8)

C (1)

STEP 1

STEP 2

Note: There will be a very small gap in-between two locked SLIP SLEEVES (D)—this is normal.

For easiest assembly, do not attach TOP POLES (B) and

BOTTOM POLES (A) until instructed. Once connected,

these will be posts for the rack.

Note that POLES (A+B) have slight horizontal line

indentations at 1” intervals. Each SLIP SLEEVE (D) has

raised horizontal lines inside designed to lock them in

place on POLES (A+B).

On BOTTOM POLE (A), place one pair of SLIP SLEEVES (D)

at desired height no higher than 3rd indentation from

bottom. Please make sure arrow faces up and word “TOP”

is right side up.

Slide pair of SLIP SLEEVES (D) until you hear a click to

confirm the pair is locked onto BOTTOM POLE (A). Do this

for each BOTTOM POLE (A) and make sure height is

identical for each BOTTOM POLE (A). Do NOT place more

than one pair on each pole at a time.

Place SHELF (C) on its side and slide each BOTTOM

POLE (A) through each corner cylinder on SHELF (C).

Make sure SHELF (C) corner cylinders are positioned

over SLIP SLEEVES (D).

Stand the unit upright.

Note:

• Level side of SHELF (C) is TOP side (TRINITY logo on

corner cylinders should be right-side up.)

• Use a rubber mallet, if needed, to secure SHELF (C).