Instructions / Assembly

ASSEMBLY INSTRUCTIONS

STEP 1: SLIP SLEEVES

STEP 2: INSTALLING BOTTOM SHELF

* For safety and stability, the lowest shelf should be lower than the 3

notch from the bottom.

** Note: There will be a very small gap in-between the SLIP SLEEVES (D)—this is normal.

A (4) D (8)

C (1)

Place SHELF (C) on its side and slide the

(4) BOTTOM POLES (A) through the

holes in the SHELF (C). Make sure that

the SHELF (C) corner cylinders are

positioned over the SLIP SLEEVES (D).

Stand the unit upright.

*Note: The level side of the SHELF (C) is

the TOP side (the TRINITY logo on the

corner cylinders should be right-side up.)

**Use a rubber mallet, if needed, to

secure the SHELF (C).

For easiest assembly, do not attach the TOP (B) and

BOTTOM (A) POLES until instructed. Once

connected, these will be the posts for the rack.

Note that each POLE (A+B) has slight horizontal line

indentations at 1” intervals. Each SLIP SLEEVE (D)

has raised horizontal lines inside designed to lock

them in place on the POLE (A+B).

On the BOTTOM POLE (A), place 1 pair of SLIP

SLEEVES (D) at the desired level. Please make

sure the arrow faces up and that the word “TOP” is

right side up. Do this for each BOTTOM POLE (A)

and make sure that the heights are identical for

BOTTOM POLE (A).

Slide the pair of SLIP SLEEVES (D) until you hear a

click to confirm the pair is locked onto the BOTTOM

POLE (A). DO NOT place more than one pair on

each POLE (A) at a time.