Warranty

ASSEMBLY INSTRUCTIONS
STEP 5
Insert (4) DOWELS (CC) in the LEFT SIDE FRAME
(B). Place (2) on each cross beam as shown.
Insert (2) CAM LOCKS (MM) to BACK FRAME (F)
with pointer arrow toward the edge.
Take LEFT SIDE FRAME (B) and align CONNECTOR
SCREWS (LL) to holes in BACK FRAME (F), then
DOWELS (CC) to UPPER SHELF (D), then LOWER
SHELF (E).
Use the SCREWDRIVER (II) to turn CAM LOCKS
(MM) in clockwise direction until BACK FRAME (F)
is pulled tight with LEFT SIDE FRAME (B).
Insert (6) SCREWS (AA) through cross beams of
LEFT SIDE FRAME (B) and fasten tightly to UPPER
SHELF (D) and LOWER SHELF (E) with the
SCREWDRIVER (II).
STEP 6
© 2017 TRINITY - 800.985.5506
5
AA
B
II
C
E
D
F
MM (2)
F (1)
II (1)
MM
Insert (2) CAM LOCKS (MM) to BACK FRAME
(F) with pointer arrow pointing toward the
edge.
Orient BACK FRAME (F) with insert nuts facing
in and long edge with holes up. Push BACK
FRAME (F) onto the CONNECTOR SCREWS (LL)
against RIGHT SIDE FRAME (C).
Use SCREWDRIVER (II) to turn CAM LOCKS
(MM) in clockwise direction until BACK
FRAME (F) is pulled tight with RIGHT SIDE
FRAME (C).
MM
AA (6) CC (4) II (1)
MM (2)
F