Warranty

ASSEMBLY INSTRUCTIONS

Note: There will be a very small gap in-between two locked SLIP SLEEVES (D)—this is normal.

A (4) D (8)

C (1)

Place SHELF (C) on its side and slide (4) BOTTOM

POLES (A) through the holes in SHELF (C). Make sure

that SHELF (C) corner cylinders are positioned over

SLIP SLEEVES (D).

Stand the unit upright.

Note:

• The level side of SHELF (C) is the TOP side (the

TRINITY logo on the corner cylinders should be

right-side up.)

• Use a rubber mallet, if needed, to secure SHELF (C).

For easiest assembly, do not attach TOP POLES (B) and

BOTTOM POLES (A) until instructed. Once connected,

these will be the posts for the rack.

Note that each POLE (A+B) has slight horizontal line

indentations at 1” intervals. Each SLIP SLEEVE (D) has

raised horizontal lines inside designed to lock them in

place on POLE (A+B).

On BOTTOM POLE (A), place 1 pair of SLIP SLEEVES (D) at

the desired level no higher than the 3

indentation from

the bottom. Please make sure the arrow faces up and

that the word “TOP” is right side up. Do this for each

BOTTOM POLE (A) and make sure that the heights are

identical for BOTTOM POLE (A).

Slide the pair of SLIP SLEEVES (D) until you hear a click to

confirm the pair is locked onto BOTTOM POLE (A). DO

NOT place more than one pair on each BOTTOM POLE (A)

at a time.

STEP 1

STEP 2