TS-20KD-1010 LOW PROFILE CARGO SCALE INSTALLATION GUIDE Triner Scale & Mfg. Co., Inc. 8411 Hacks Cross Rd.
Description The Triner Scale Model TS-20KD-1010 Low Profile Cargo Scale with wrap around ramps is designed for dependable daily use and precision built for year after year accuracy. Only three inches high, it is designed to accommodate tugs, aircraft carts, dollies, and pallet jacks.
6. Connect six (6) load cells to summing junction box. 7. Connect home run cable from the junction box to the digital indicator. 8. Perform corner test with 2,000 lbs of test weight. 9. Calibrate the scale per digital indicator manual. Weldment #1 Installation 1. Choose an area of concrete where the scale is to be installed. The area should be level and free of debris. Be sure to install the scale so the traffic runs parallel to the center seam (see Figure 1).
9. Drill holes into the concrete with ½” concrete bit to anchor the load cell stands. Install and tighten all anchor bolts, except the two near the center seam of the scale (see Fig 1). In the two holes near the center seam (see Fig 1), DO NOT use the nuts or washers. Simply hammer the anchor bolt flush with the top of the load cell stand. This will ensure that the anchor bolt will not touch the bottom of Platform Weldment #2 when it is put in place.
3. Make sure to place the side ramp with cable exit notches where the load cell cables exit. 4. When all ramps are properly aligned, use ½” concrete bit to drill the holes. Install all anchor bolts and tighten them securely. Platform to Junction Box Connection 1. Locate an area, approximately 5 feet away from the scale, in which to mount the indicator/summing junction stand. Secure the stand to the ground with four ½” anchor bolts. 2. Mount the junction box to the stand with the hardware provided. 3.
Final Calibration Calibrate the scale system with a minimum of 5,000 lbs of test weight per the digital indicator manual.
