Instruction Manual

14
Or
 Change the piece weight value by using the  or  and  keys.
 The display shows the new piece weight.
 To accept the new value press ENTER ().
 The display shows the number of pieces currently on the scale.
To return to the normal weigh mode press the key.
SUMMING
The indicator offers the possibility to add weighings and show the total weight. When
a tare weight is active, the net weight is added automatically.
 Load the system with the weight that should be added.
 Press the key to add the weighed load to the total weight.
 The display shows the message “ADDED” and after a short delay returns to
the weighing mode.
Note that no weight can be recorded twice. The system needs to be returned to the
net zero-range before another weight can be added up.
 To check the subtotal can be checked by pressing the key for 3 seconds.
 The display shows the net total weight and the number of weightings totaled
so far repeatedly for 3 seconds.
 If the key is pressed during this period, the total is printed out (if option
is installed) and reset to 0.
 If the “CE” key is pressed during this period, the total is reset but not
printed out.
 If no key is pressed during this period, the subtotal stays in memory and
the system returns to the weighing mode after 60 seconds.
CHANGE UNITS
The system is set to start up in „lbs‟ or in „kg‟. However you may, at any time in the
weighing mode, change to the second unit (lbkg or kglb).
 Press the key for 3 seconds.
❏ The display will show the current weight in the new units for 5 seconds and
then automatically change back to the start up units.
Note: The same key is used to change from the piece counting mode back to the
weighing mode.