Manual
Table Of Contents
- MP-20
- 2.pdf
- 6.pdf
- cover MP20.pdf
- cover MP20.pdf
- 2.pdf
- 6.pdf
- cover MP20.pdf
- 2.pdf
- 6.pdf
- Character mode
- 2Command Line mode
- Maximum number of letters printable on paper
- Start coordinate (x, y)
- Barcode direction
- Inter-character gap (dot)
- Narrow bar width (dot)
- Wide bar width (dot)
- Bar height (dot)
- With human-readable text
- Human-readable text font
- Human-readable text position
- Bx,y,rotate,height,withAscii,”text”\(
3.2 System Status
Lamp Condition System Status Description Action
Steady Green READY System ready to accept any command and data
input
Send command or data to printer
Flashing Green PROCESSING System is processing a command(s) Wait for process to finish
Steady Red CMDERR Command format error, or command/data buffer
overflow
Clear error state by pressing CLR key, and then
resend all commands after the one that caused the
error
Flashing Red SYSERR System error. May result from one of the
following reasons: Paper out, head in up position,
or over heat condition
Check paper, printer head, or wait a while for printer to
cool down in case of overheat
Amber PENDING Task pending. Happens after self-test page has
finished
Send command to print test page again, or switch to
another mode and then change pending state to Ready
3-2