Datasheet
TMCM-3314 TMCL
™
Firmware Manual • Firmware Version V1.09 | Document Revision V1.07 • 2017-DEC-01
75 / 109
Number Axis Parameter Description Range [Units] Access
116 CL correction
velocity I
Parameter I of PI regulator which controls the
maximum velocity during closed loop regulation.
0. . . 16777215 RW
117 CL correction
velocity I
clipping
Clipping of the error sum of the integral part of
the PI regulator which controls the maximum
velocity during closed loop regulation.
0. . . 32767 RW
118 CL correction
velocity DV
clock
Clock divider for D part calculation. 0. . . 32767 RW
119 CL correction
velocity DV
clipping
Limit maximum velocity deviation above the
maximum velocity.
0. . .
2147483647
RW
120 CL upscale
delay
Delay when increasing motor current during
closed loop operation.
0. . . 16777215 RW
121 CL downscale
delay
Delay when decreasing motor current during
closed loop operation.
0. . . 16777215 RW
124 CL correction
position P
Proportional controller P parameter for compen-
sating a detected position deviation. Resulting P
parameter is this parameter divided by 65536.
0. . . 16777215 RW
125 CL max.
correction
tolerance
Tolerance range for position deviation. 0. . . 255 RW
126 CL start up
Tolerance range for position deviation. If posi-
tion deviation is within the CL start up window
the current will not ramp up.
0. . . 255 RW
127 Relative
positioning
option
Start position for MVP REL command:
0 last target position
1 actual position
2 encoder position
0/1 RW
129 Closed Loop
Flag
0 - closed loop off
1 - closed loop on
After switching on closed loop, please wait until
parameter #133 is 1 before executing any mo-
tion commands.
0/1 RW
131 measured
speed
Speed measured using the encoder. -2147483648
. . . 2147483647
[pps]
R
132 current
measured
speed
Speed measured using the encoder, without av-
eraging.
-2147483648
. . . 2147483647
[pps]
R
133 Closed Loop
Init Flag
0 - initialization not finished yet
1 - closed loop initialization finished
0/1 R
©2018 TRINAMIC Motion Control GmbH & Co. KG, Hamburg, Germany
Terms of delivery and rights to technical change reserved.
Download newest version at www.trinamic.com