User Manual
TMCM-1276 TMCL
™
Firmware Manual • Firmware Version V1.13 | Document Revision V1.01 • 2019-MAR-20
9 / 100
Most important axis parameters
Number Axis Parameter Description Range
[Units]
Access
4 Maximum
positioning
speed
The maximum speed used for positioning ramps. 0. . . 7999774
[pps]
RW
5 Maximum
acceleration
Maximum acceleration in positioning ramps. Ac-
celeration and deceleration value in velocity
mode.
0. . . 7629278
[pps
2
]
RW
6 Maximum
current
Motor current used when motor is running. The
maximum value is 255 which means 100% of the
maximum current of the module.
The current can be adjusted in 32 steps:
0. . . 7 79. . . 87 160. . . 167 240. . . 247
8. . . 15 88. . . 95 168. . . 175 248. . . 255
16. . . 23 96. . . 103 176. . . 183
24. . . 31 104. . . 111 184. . . 191
32. . . 39 112. . . 119 192. . . 199
40. . . 47 120. . . 127 200. . . 207
48. . . 55 128. . . 135 208. . . 215
56. . . 63 136. . . 143 216. . . 223
64. . . 71 144. . . 151 224. . . 231
72. . . 79 152. . . 159 232. . . 239
The most important setting, as too high values can
cause motor damage.
0. . . 255 RW
7 Standby
current
The current used when the motor is not running.
The maximum value is 255 which means 100% of
the maximum current of the module. This value
should be as low as possible so that the motor
can cool down when it is not moving.
0. . . 255 RW
Table 1: Most important Axis Parameters
2.4 Testing with a simple TMCL Program
Now, test the TMCL stand alone mode with a simple TMCL program. To type in, assemble and download
the program, you will need the TMCL creator. This is also a tool that can be found in the tool tree of
the TMCL-IDE. Click the TMCL creator entry to open the TMCL creator. In the TMCL creator, type in the
following little TMCL program:
1
ROL 0, 51200 //Rotate motor 0 with speed 10000
WAIT TICKS , 0, 500
3
MST 0
ROR 0, 51200 // Rotate motor 0 with 50000
5
WAIT TICKS , 0, 500
MST 0
©2019 TRINAMIC Motion Control GmbH & Co. KG, Hamburg, Germany
Terms of delivery and rights to technical change reserved.
Download newest version at www.trinamic.com