User Manual

TMCM-1276 TMCL
™
Firmware Manual • Firmware Version V1.13 | Document Revision V1.01 • 2019-MAR-20
81 / 100
5.4 Bank 3
Bank 3 contains interrupt parameters. Some interrupts need configuration (e.g. the timer interval of
a timer interrupt). This can be done using the SGP commands with parameter bank 3 (SGP <type>, 3,
<value>). The priority of an interrupt depends on its number. Interrupts with a lower number have
a higher priority.
Table 18 shows all interrupt parameters that can be set. Please see table 15 for an explanation of the
parameter access types.
Interrupt Parameters in Bank 3
Number Global Parameter Description Range [Units] Access
0 Timer 0 period
(ms)
Time between two interrupts 0. . . 4294967295
[ms]
RW
1 Timer 1 period
(ms)
Time between two interrupts 0. . . 4294967295
[ms]
RW
2 Timer 2 period
(ms)
Time between two interrupts 0. . . 4294967295
[ms]
RW
27 Stop left 0 trigger
transition
0=off, 1=low-high, 2=high-low, 3=both 0. . . 3 RW
28 Stop right 0 trigger
transition
0=off, 1=low-high, 2=high-low, 3=both 0. . . 3 RW
39 Input 0 trigger
transition
0=off, 1=low-high, 2=high-low, 3=both 0. . . 3 RW
40 Input 1 trigger
transition
0=off, 1=low-high, 2=high-low, 3=both 0. . . 3 RW
41 Input 2 trigger
transition
0=off, 1=low-high, 2=high-low, 3=both 0. . . 3 RW
Table 18: Interrupt Parameters in Bank 3
©2019 TRINAMIC Motion Control GmbH & Co. KG, Hamburg, Germany
Terms of delivery and rights to technical change reserved.
Download newest version at www.trinamic.com