User Manual

TMCM-1276 CANopen
®
Firmware Manual • Firmware Version V3.22 | Document Revision V1.00 • 2018-JUN-28
50 / 114
Entry Description
Sub-index Access PDO Mapping Value Range Default Value
0 rw no 0. . . 255 0
Table 129: Entry Description (20B5
h
)
4.2.40 Object 20B6
h
: Fullstep Threshold Speed
Depending on the settings of objects 20B7
h
and 20B8
h
(see sections 4.2.41 and 4.2.42) the driver switches
to fullstep mode and/or to a different chopper mode when the speed set by this object is exceeded.
Object Description
Index Name Object Type Data Type
20B6
h
Fullstep Threshold Speed Variable UNSIGNED32
Table 130: Object Description (20B6
h
)
Entry Description
Sub-index Access PDO Mapping Value Range Default Value
0 rw no 0. . . 16777215 0
Table 131: Entry Description (20B6
h
)
4.2.41 Object 20B7
h
: High Speed Chopper Mode
The motor driver will switch to a different chopper mode when this object is set to 1 and the measured
speed is greater than the threshold speed set by object 20B6
h
(see section 4.2.40).
Object Description
Index Name Object Type Data Type
20B7
h
High Speed Chopper Mode Variable UNSIGNED8
Table 132: Object Description (20B7
h
)
Entry Description
Sub-index Access PDO Mapping Value Range Default Value
0 rw no 0/1 0
Table 133: Entry Description (20B7
h
)
4.2.42 Object 20B8
h
: High Speed Fullstep Mode
The motor driver will switch to fullstep mode when this object is set to 1 and the measured speed is greater
than the threshold speed set by object 20B6
h
(see section 4.2.40).
©2018 TRINAMIC Motion Control GmbH & Co. KG, Hamburg, Germany
Terms of delivery and rights to technical change reserved.
Download newest version at www.trinamic.com