User Manual
TMCM-1260 TMCL
™
Firmware Manual • Firmware Version V1.44 | Document Revision V1.02 • 2018-SEP-05
5 / 107
1 Features
The TMCM-1260 is a single axis controller/driver module for 2-phase bipolar stepper motors with state
of the art feature set. It is highly integrated, offers a convenient handling and can be used in many
decentralized applications. The module can be mounted on the back of NEMA 23 or NEMA 24 (57mm
or 60mm flange size) stepper motors and has been designed for coil currents of up to 6A RMS and 48V
DC supply voltage. With its high energy efficiency from Trinamic’s CoolStep
™
technology cost for power
consumption is kept down. The TMCL firmware allows for standalone operation and direct mode control.
Main characteristics
• Motion controller & stepper motor driver:
– Hardware motion profile calculation in real-time.
– On the fly alteration of motion parameters (e.g. position, velocity, acceleration).
–
High performance microcontroller for overall system control and communication protocol
handling.
– Up to 256 microsteps per full step.
– High-efficient operation, low power dissipation.
– Dynamic current control.
– Integrated protection.
– StallGuard2™ feature for stall detection.
– CoolStep™ feature for reduced power consumption and heat dissipation.
– StealthChop™ feature for quiet operation and smooth motion.
– DcStep™ feature for load dependent speed control.
• Encoder
– SensOstep™ magnetic encoder with 1024 increments per round.
–
Usable for example for step-loss detection under all operating conditions and positioning
supervision.
– Interface for additional external encoder.
• Interfaces
– USB interface.
– RS485 bus.
– CAN bus.
– Step/Direction inputs.
–
Three general-purpose digital inputs (Alternate functions: home switch, quadrature encoder
input).
– One dedicated analog input.
– Two stop switch inputs.
– One general purpose digital output (open drain max. 1A).
Software
TMCL remote controlled operation via USB, RS485 or CAN interface and/or stand-alone operation via TMCL
programming. PC-based application development software TMCL-IDE available for free.
©2019 TRINAMIC Motion Control GmbH & Co. KG, Hamburg, Germany
Terms of delivery and rights to technical change reserved.
Download newest version at www.trinamic.com