User Manual

TMCM-1240 CANopen
®
Firmware Manual • Firmware Version V3.22 | Document Revision V1.01 • 2018-DEC-03
47 / 118
Object Description
Index Name Object Type Data Type
209E
h
stallGuard2 Threshold Variable SIGNED8
Table 113: Object Description (209E
h
)
Entry Description
Sub-index Access PDO Mapping Value Range Default Value
0 rw no -63. . . 63 0
Table 114: Entry Description (209E
h
)
4.2.31 Object 20A1
h
: Short Protection Disable
This object is used to enable or to disable the short to ground protection. Normally there is no need to
change this. Use the default value.
Possible values are:
• 0 – Short to GND protection enabled
• 1 – Short to GND protection disabled
Object Description
Index Name Object Type Data Type
20A1
h
Short Protection Disable Variable UNSIGNED8
Table 115: Object Description (20A1
h
)
Entry Description
Sub-index Access PDO Mapping Value Range Default Value
0 rw no 0/1 0
Table 116: Entry Description (20A1
h
)
4.2.32 Object 20A4
h
: Stop on Stall
Below this speed the motor will not be stopped. Above this speed the motor will be stopped in case the
stallGuard2 load value reaches zero.
Object Description
Index Name Object Type Data Type
20A4
h
Stop on Stall Variable UNSIGNED32
Table 117: Object Description (20A4
h
)
©2018 TRINAMIC Motion Control GmbH & Co. KG, Hamburg, Germany
Terms of delivery and rights to technical change reserved.
Download newest version at www.trinamic.com