User Manual

TMCM-1160 V1.01 Hardware Manual (Rev. 1.01 / 2012-JUL-27) 6
www.trinamic.com
3 Mechanical and Electrical Interfacing
3.1 Dimensions and Mounting Holes
- The dimensions of the TMCM-1160 controller/driver board are approx. 60 mm x 60 mm in order to fit
on the back side of the 60 mm stepper motor.
- Maximum component height above PCB level without mating connectors is around 10.5 mm
(jumpers for RS485 / CAN termination included).
- Maximum component height below PCB level is around 4 mm.
- There are four mounting holes for M3 screws for mounting the board either to a NEMA23 (two
mounting holes at opposite corners) or a NEMA24 (other two mounting holes at opposite corners)
stepper motor.
60
60
56.75
46.25
49.5
10.5
4.59
45.95
13.75
3.25
10.5
55.41
14.05
Figure 3.1 Dimensions and mounting holes