User Manual

TMCC160 CANopen
®
Firmware Manual • Firmware Version V3.00 | Document Revision V1.00 • 2017-Aug-29
71 / 86
8.3 How to start a Homing in hm Mode
Here is a little example that shows how to home the motor in hm mode. In this little example we assume
that the module has been reset (and then switched to pre-operational or operational) by NMT commands
before. The home switch must be connected to the home switch input. It can be operated manually.
• Select hm mode by writing 6 to object 6060
h
.
• Write 6 to object 6040
h
to switch to READY_TO_SWITCH_ON state.
• Write 7 to object 6040
h
to switch to SWITCHED_ON state.
• Write 15 to object 6040
h
to switch to OPERATION_ENABLED state.
• Select homing method 17 (or 18) by writing 17 (or 18) to object 6098
h
.
• Set the homing speeds by writing e.g. 500 to object 6099
h
sub index 1 and e.g. 200 to object 6099
h
sub index 2.
• Write 31 to object 6040
h
to start the homing process.
• Press and release the home switch.
• When homing has finished, write 15 to object 6040
h
again.
©2017 TRINAMIC Motion Control GmbH & Co. KG, Hamburg, Germany
Terms of delivery and rights to technical change reserved.
Download newest version at www.trinamic.com
Read entire documentation.