Datasheet

TMC8462 Datasheet • Document Revision V1.5 • 2019-June-21
57 / 204
6.4.4.3 ESC DL Control (0x0100:0x0103)
Bit Description ECAT PDI Reset Value
0 Forwarding rule:
0: EtherCAT frames are processed,
Non-EtherCAT frames are forwarded without
processing
1: EtherCAT frames are processed, Non-
EtherCAT frames are destroyed
The source MAC address is changed for every
frame (SOURCE_MAC[1] is set to 1 - locally ad-
ministered address) regardless of the forward-
ing rule.
r/- r/-
1 Temporary use of settings in Register 0x101:
0: permanent use
1: use for about 1 second, then revert to previ-
ous settings
r/- r/-
7:2 Reserved, write 0 r/- r/-
9:8 Loop Port 0:
00: Auto
01: Auto Close
10: Open
11: Closed
Note Loop open means sending/receiving over
this port is enabled, loop closed means send-
ing/receiving is disabled and frames are for-
warded to the next open port internally. Auto:
loop closed at link down, opened at link up
Auto Close: loop closed at link down, opened
with writing 01 again after link up (or receiving
a valid Ethernet frame at the closed port) Open:
loop open regardless of link state Closed: loop
closed regardless of link state
r/w* r/-
11:10 Loop Port 1:
00: Auto
01: Auto Close
10: Open
11: Closed
r/w* r/-
13:12 Loop Port 2:
00: Auto
01: Auto Close
10: Open
11: Closed
r/w* r/-
15:14 Loop Port 3:
00: Auto
01: Auto Close
10: Open
11: Closed
r/w* r/-
©2019 TRINAMIC Motion Control GmbH & Co. KG, Hamburg, Germany
Terms of delivery and rights to technical change reserved.
Download newest version at www.trinamic.com