Datasheet

TMC8462 Datasheet • Document Revision V1.5 • 2019-June-21
17 / 204
Name Pin Type (I,O,PU,PD) Function
EEPROM IOs
PROM_INIT J5 O Signal indicating that EEPROM has been loaded,
0 = not ready, 1 = EEPROM loaded
PROM_CLK H4 O External I2C EEPROM clock signal, use 1K pull
up resistor to 3.3V
PROM_DATA H5 I/O External I2C EEPROM data signal, use 1k pull up
resistor to 3V3
PROM_SIZE G9 I Selects between two different EEPROM sizes
since the communication protocol for EEPROM
access changes if a size > 16kBit is used (an ad-
ditional address byte is required then). 0 = up to
16kBit EEPROM, 1 = 32 kBit-4Mbit EEPROM
DC Synchronization IOs
SYNC_OUT0 D7 O Distributed Clocks synchronization output 0, typ-
ically connect to MCU
SYNC_OUT1 D6 O Distributed Clocks synchronization output 1, typ-
ically connect to MCU
LATCH_IN0 C7 I Latch input 0 for Distributed Clocks, connect to
GND if not used.
LATCH_IN1 C6 I Latch input 1 for Distributed Clocks, connect to
GND if not used.
LEDs
LED_RUN B3 O Run Status LED, connect to green LED (Anode) 0
= LED off, 1 = LED on
LED_ERR C3 O Error Status LED, connect to red LED (Anode) 0 =
LED off, 1 = LED on
LINK_ACT0 D3 O Link In Port Status and Activity, connect to green
LED (Anode) 0 = LED off, 1 = LED on
LINK_ACT1 E3 O Link Out Port Status and Activity, connect to
green LED (Anode) 0 = LED off, 1 = LED on
©2019 TRINAMIC Motion Control GmbH & Co. KG, Hamburg, Germany
Terms of delivery and rights to technical change reserved.
Download newest version at www.trinamic.com